Description:

PILOT Boxy 131S, film-applied ARF finished sport plane
Thick wing with a perfectly symmetrical airfoil and rectangular wings. It is difficult to stall and recover even when performing drastic aerobatic maneuvers. The new wing structure is not visible from the outside, but it is highly rigid and lightweight.

Suitable for intermediate level fliers.
Completed with film
Glow engine type
Glow engine specification

< Technical Data >

Overall Length：1130mm
Wing Span：1310mm
Wing Area：31.3dm2
Overall Weight：1700-1800g
Motor: Tahmazo ER-281411dBM(48802)
Engine: 2C25-40 class
Radio: AL(2), RD, EV, TH or ESC
Difficulty: Intermediate
Completed condition: Completed with film
Power Unit: Electric motor/Glow engine

< Items required before flight >

Propo transmitter/receiver for airplanes
Servos Standard servos* x 3
Mini Servo Tahmazo TS-D1134MG(48908)x2
Engine mount or motor mount
Fuel tank (approx. 200cc)
Spinner - 51mm
Engine 2-cycle 25~40 class
Brushless motor
APC propeller 9x5~11x5
Extension cords PILOT ST200mm (47499) x2 PILOT ST100mm (47498) x2 
        *Depends on the servo to be used.
Instant adhesive OK Bond HW (43010), FX (43451)
Epoxy adhesive (30-minute curing type)
Silicone adhesive
Pilot sanding block (25042)
Sandpaper
Other general tools (cutter knife, screwdriver, etc.)
Standard servos are servos with a width of 20 mm, length of 40 mm, and torque of 3.5 kg or more manufactured by a radio manufacturer.
If you choose electric power as the power source, you can easily use ePack25.

*This product does not include engine mount, fuel tank, motor mount, or spinner.
  Please prepare them according to the power source to be used.

<Main Set Contents>

Balsa ribbed main wings with film applied
Balsa ribbed tail wing with film applied
Wooden fuselage with film applied and finished
Jura main gear
Japanese assembly instruction manual

*This product is a film-applied finished ARF airplane. Some work is required to complete the aircraft, such as joining the main wing, engine, and mechanical components.
*Covering film may have some wrinkles due to its material. In such cases, the film can be removed by applying heat with a modeling iron to shrink the film.
*The contents, design, and colors of the set are subject to change without notice.